Filter
Top Products
68
CHAPTER 3 CPU
3.12.6 Reset Factor Retention
The reset factor retention holds the factor of previous generation. All flag is cleared to
"0" by reading.
Once a factor flag is set, it is not cleared unless the factor is read.
■ Block Diagram of Reset Factor Retention Circuit
Figure 3.12-8 Reset factor circuit Block Diagram
■ Setting of Reset Factor Retention
No special settings are required to use the rest factor function. Commands for reading the reset factor
register and branching to the appropriate program shall be placed near the front of the program to be set in
the reset entry address.
[example]
RESET-ENTRY
LDI:32 #RSRR,R10
LDI:8 #10000000B,R2
LDUB @R10,R1 ; GET RSRR VALUE INTO R1
MOV R1,R10 ; R10 USED AS A TEMPORARY REGISTER
AND R2,R10 ; WAS PONR RESET?
BNE PONR-RESET
LSR #1,R2 ; POINT NEXT BIT
MOV R1,R10 ; R10 USED AS A TEMPORARY REGISTER
AND R2,R10 ; WAS WATCH DOG RESET?
BNE WDOG-RESET
...
RST pin
Internal bus
State
transition
circuit
ERST
PONR
WDOG
SRST
Reset input circuit ERST
PONR
WDOG
SRST
watch-dog Timer
reset detect Circuit
SRST
decoder
.o r.
Power-on
detection