Filter
Top Products
WN-5230-S VideoWall User’s Guide
103
Function
RS-232 COMMANDS
Inc Dec
RS-232
DATA
Get Set
Comments
Auto re-strike Controls
System status request S0$ Bit 7: Lamp status (1=on; 0=off)
Bit 6: Lamp failure (1=fail; 0=OK)
Bit 5: Not used
Bit 4: Not used
Bit 3: System state: bit 3
Bit 2: System state: bit 2
Bit 1: System state: bit 1
Bit 0: System state: bit 0
The system state can have the
following values
0000 – Lockout state
0001 – Standby state
0010 – Run state
0011 – Force on ignition state
0100 – Manual ignition state
0101 – Ignition state
0110 – Re-strike state
All others are not used.
Enable / Disable Auto re-strike LF1 LF0 LF* LF1 – auto re-strike active
LF0 – auto re-strike inactive
Test Signal Controls
Test Signal Disable (Pass Video) TSD TS* TSD removes test signal and allows
video to show. 0 = off,
1 = White, 2 = Black, 3 = Gray,
4 = Red, 5 = Green, 6 = Blue,
7 = Geometry red, 8 = Gmtry cyan,
9 = Gmtry black, 10 = Gray Ramp
Test Signal - White Field WHT
Test Signal - Black Field BLK
Test Signal - 50% Gray Field GRY
Test Signal - Red Field RED
Test Signal - Green Field GRN
Test Signal - Blue Field BLU
Test Signal - Geometry red GE1
Test Signal - Geometry cyan GE2
Test Signal - Geometry black GE3
Test Signal - Gray ramp GE4
Test Signal - TS* 0 = off, 1 = on
Test Signal - Data Red TR# Set test signal red level 0-255
Test Signal - Data Green TG# Set test signal green level 0-255
Test Signal - Data Blue TB# Set test signal blue level 0-255
System Monitor
Ping PNG Verifies that a cube is at an address
Product ID P00 Gets the product ID (hex)
In the About menu, the project
number is 573-xxyy-zz. The xx value
is returned as a hex number.
Version ID VER Get software version ID
0x01 – Rev A
0x02 – Rev B
0x03 – Rev C
etc.
Big Picture Controls
Wall Horizontal Size WXn WX$ n=1..4
Wall Vertical Size Wyn WY$ n=1..4
Wall Mode Calculate WMC
Wall Mode On/Off WM1 WM0 WM* WM* returns WM1 or WM0
Protocol Control (1)
Received Valid Command ACK Command successfully executed.
Received Invalid Command NAK Command error on execution.
Unknown command UNK Unknown command.