Filter
Top Products
WN-5230-S VideoWall User’s Guide
11
Power Consumption
Typical power consumption of the WN-5230-S is 160 Watts, but the
maximum potential of 200 Watts should be used for calculating the load on
the power source. At 200 Watts the current draw is approximately 1.7 Amps
at 115 VAC (0.9 Amps at 230 VAC).
Voltage Range
The WN-5230-S will operate between 100 and 240 volts AC at 50/60Hz.
Since the power module is auto ranging, there is no manual selector switch.
The main power switch on the power module also acts a circuit
breaker. If power to the display is lost, check the power/breaker
switch by turning it off and then back on.
The power switch is a lighted switch. When it is lit, it indicates that the
AC power is applied and the power switch is on.
WARNING Displays that are intended for 240V configuration must have a
properly rated power supply cord and attachment plug supplied
by the installer.
WARNING
If extension cords are used for power, ensure that only 3-prong
grounded cords sized to handle system power requirements are
used. Using the wrong-size extension cord can cause a fire-
safety hazard and can reduce the voltage available to the
WN-5230-S. If the extension cord is warm to the touch it is too
small and should be immediately removed from operation.
WARNUNG
Falls für die Stromversorgung Verlängerungskabel benutzt
werden, achten Sie bitte darauf, daß nur geerdete, dreipolige und
für die vorgesehene Leistungsaufnahme ausgelegte Netzkabel
benutzt werden. Die Verwendung eines unterdimensionierten
Verlängerungskabels stellt eine potentielle Feuersgefahr dar und
kann dazu führen, daß die für den WN-5230-S Video-Monitor
verfügbare Spannung zu gering ist. Falls das
Verlängerungskabel sich fühlbar erwärmt, heißt das, daß das
Verlängerungskabel unterdimensioniert ist. Es muß dann sofort
aus dem Verkehr gezogen werden.
WARNING Hazardous voltages inside the display and power module can
shock, burn and cause death. Only the WN-5230-S lamp and air
filter are user serviceable. Always turn off and disconnect power
before servicing these items. Refer all other service to a qualified
service center. Failure to do so could result in electrical shock,
ultraviolet radiation burns, contact heat burns, serious injury, or
irreparable damage to the WN-5230-S and may void your factory
warranty.