Filter
Top Products
WN-5230-S VideoWall User’s Guide
55
Assign each display a unique address using the Unit
ID knob. Both the Group and Unit ID numbers are
used
The address of the display in the upper left corner (as
seen from the front) must be zero. The addresses of
the other displays must increase left to right, top
bottom, increasing by one for each display. Therefore,
the display in the lower right corner (as seen from the
front) always has the highest address.
00 01
02 03
2x2 example $
(Seen from the
front)
0 1 2
3 4 5
7. Set each display’s address
(See note below for walls
larger than 4x4.)
3x3 example $
6 7 8
8. Set the Wall Size on each
display
Open the Wall Processor menu. Enter the horizontal
and vertical wall size. Each display’s menu should
show the same horizontal and vertical wall size.
Each display should show a different Current Unit
value. This value represents its location in the wall.
Note: Clarity’s Big Picture handles up to a 6x6 video wall. Because the Unit
knob only has 16 positions, the Group knob must be used for all walls that
have more than 16 displays. A 6x6 wall would be numbered like this (top
number is Group; bottom number is Unit):
00 01 02 03 04 05
06 07 08 09 0A 0B
0C 0D 0E 0F 10 11
12 13 14 15 16 17
18 19 1A 1B 1C 1D
1E 1F 20 21 22 23