Filter
Top Products
WN-5230-S VideoWall User’s Guide
91
Menus
Notes for menu descriptions:
* This command is also available from a special button on the remote control.
† In the Color Balance menu, the up-down arrows move the highlight through the two
columns. The left-right arrows change the highlighted value.
‡ This command is available only from a special button on the remote control.
§ The numbers in this menu are for reference only; they are not measurements.
Main Menu
Source*
Opens the Source Select menu
Frequency*
Opens the Frequency adjust window
Phase*
Opens the Phase adjust window
Input Level*
Opens Input Level menu (when PC, MAC or RGBS is the selected
source) or Video Controls menu (when Composite or S-video is the
selected source)
Position
Opens the Position window
Zoom
Opens the Zoom menu
Wall Processor
Opens the Wall Processor menu
Color Balance*
Opens the Color Balance menu
Curtain*
Opens Curtain menu
Hours
Opens Hours menu
Save Config
Opens Save Config(uration) menu
Recall Config
Opens Recall Config(uration) menu
Reset Config*
Opens Reset Config(uration) menu
Misc Control
Opens Misc(ellaneous) Control menu
About
Opens About menu
Source Select
#
##
# $
$$
$ [source]
[source] is one of the following:
PC
MAC
9-pin (RGBS)
BNC (RGBS)
C-Video
S-Video
#
##
# $
$$
$ [mode]
[mode] is one of the following:
640x480
800x600
525/60Hz
625/50Hz
[ ] Auto
Detects and sets the mode parameters for a selected source
[ ] Sync on Green
Forces Sync on Green for RGBS, in case auto detection does not find
this correctly
[ ] Interlace
Indicates that the source video is interlaced; cannot by changed
manually.
H Freq: 00000
Shows H rate in Hertz of selected source
Lines: 000
Shows total number of horizontal lines in the selected source
V Freq: 00
Shows frame rate in Hertz of selected source