Filter
Top Products
Clarity Visual Systems
September 1999
68
8. Detach the lamp
cable
Using your thumb and middle finger to unlock the lamp cable
connector, use your index finger to pull the connector away from
the lamp.
The lamp cable will remain connected to the optical engine.
9. Remove the lamp
Push the lamp to the right (into the optical engine) while turning
counterclockwise. The lamp will rotate about an eighth of a turn,
and then it can be pulled to the left (out) and removed.
10. Install the new lamp
and reassemble the
display
Reinsert a UHP 100W lamp in the same orientation. Push the
lamp in and rotate the lamp clockwise until it locks into place.
When attaching the lamp cable, pinch the connector clamp
together while inserting the connector. The connector is keyed
so it will only go on one way.
Replace the lamp access door on the optical engine.
Close and latch the projector compartment hood.
11. Reinstall
Reinstall the screen by lining up the latches and pressing the
screen inward. It will go in with a distinct “pop.” Give it a slight
pull to see that it is securely in place.
Removing a Standard Screen Using the Screen Removal Tool
1. Find the bumps on
the side mullions
On both sides of the screen, near the top and bottom, the
mullion is slightly lifted from the screen material, forming a
little bump. The removal tool fits here.
2. Insert the removal
tool
The small hook on the removal tool slips under the bump in
the mullion. The other side of the tool should press against the
mullion of the neighboring screen. Use care when using the
tool so it doesn’t scratch the screen material.
3. Squeeze the handle
of the SRT-100
Squeezing the handle of the removal tool pulls one screen out
far enough to let it “pop” out at that corner. The tool uses the
neighboring screen for leverage.
4. Repeat for all four
corners
Remove the screen carefully and set it aside.