Filter
Top Products
Clarity Visual Systems
September 1999
64
Reset Lamp Hours
After you change the lamp, use this menu to reset the lamp hour timer
to zero. Lamp hours count up whenever the VideoWall is running (FAN
and LAMP LEDs are on). The system hour timer displays the total
hours that power has been applied to the VideoWall with the power
supply switch on. The system hour timer cannot be reset.
Source Select
Frequency
Phase
Input Level
Position
Zoom
Wall Processor
Color Balance
Curtain
Hours
Save Config
Recall Config
Reset Config
Misc Control
About
Lamp Hours: 5987:34
System Hours: 10886:29
Reset Lamp Hours?
[ ] Yes [X] No
1. Press the MAIN MENU
button on the remote
The Main menu is displayed.
2. Press the up/down
arrow keys
Move the cursor to the Hours selection.
3. Press ENTER
The Lamp Hours menu displays the current number of
lamp operating hours. Replace the lamp at 8,000 hours.
This menu also shows total system hours.
4. Press left/right arrow
keys
Use the left or right arrow keys to highlight the Yes
selection.
5. Press ENTER
Press the ENTER button to proceed in resetting the lamp
hours to zero.
6. Press left/right arrow
keys
At this point a warning will prompt ‘Did You Replace The
Lamp?’ If the lamp was replaced, use the left or right
arrow keys to highlight the Yes selection.
7. Press ENTER
Press the ENTER button to proceed in resetting the lamp
hours to zero.