Filter
Top Products
Clarity Visual Systems
September 1999
52
Turning off the System
Turning off the Display, Entering Standby Mode
When the OFF button on the remote is pressed, the display will power down
and, after about 5 seconds, the STANDBY LED will turn on. When the
STANDBY LED is on, the display is in the standby mode and is ready to be
turned on again.
Turning off the Main Power Switch
Turn off the main power switch only for servicing or moving the display or if
the display will not be used for an extended period of time.
The main power switch on the power module also acts a circuit breaker. If
power to the display is lost, check the power/breaker switch by turning it off
and then back on.
The power switch is a lighted switch. When it is lit, it indicates that the AC
power is applied and the power switch is on.
Figure 5 Block diagram of memory system
Active
Settings
Saved
Memory
Factory
Default
Values
Save
Reset
Recall