Filter
Top Products
WN-5230-S VideoWall User’s Guide
69
Figure 6 SRT-100, Screen Removal Tool
Lamp Replacement, Rear Access, Any Screen Type
1. Turn off the power
Switch off the WN-5230-S using the remote and allow the
cooling cycle to complete (30 seconds) before switching
off the AC power at the rear-panel switch.
2. Unplug power cord
Remove the AC power cord from the display.
3. Remove the rear
access cover
Unfasten the 9 quarter-turn screws on the rear access
cover and remove the cover.
4. Remove the lamp
access door
On the right side of the optical engine is the lamp access
door. Pull on the latch to open and remove the door.
5. Detach the lamp
cable
Using two fingers to unlock the lamp cable connector
clamp, use a third finger to pull the connector away from
the lamp.
The lamp cable will remain connected to the optical
engine.
This hooks under
the bump in the
mullion
These 2 parts push
against the mullion
of the neighboring
screen.