Filter
Top Products
Clarity Visual Systems
September 1999
22
Mechanical Setup
The mechanical setup is broken down into three processes - the physical
assembly of the wall, the attachment of cables to each display and the
setting of each display’s number, or address, in the wall. The WN-5230-S
comes with either a standard screen, an Ultra-Thin Mullion Screen, or a
Blackscreen™. (Blackscreen has the same dimensions as the Ultra-Thin
Mullion.)
• The standard screen has a mullion about 1/8
th
inch (3 mm) wide.
The mullion is a strip of sheet metal surrounding the screen and
holds it in place.
• The Ultra-Thin Mullion Screen, or mullionless screen, does not
have the 1/8
th
inch strip of metal around the screen. The edge of
the screen goes right to the edge of the display unit. This makes
the lines between display units much less apparent in the finished
video wall.
• BlackScreen™, a mullionless screen as above, but with a higher
contrast ratio.
Mechanical Setup, Standard Screen
Install the WN-5230-S in the desired position and connect the power and
signal cables. See the following section for an explanation of the cabling
configuration.
Figure 3 Connecting display units