Filter
Top Products
4-8 1. Ethernet
Transferring Screen Data
This section describes the procedure for transferring screen data from the V-SFT editor on
the server to MONITOUCH via Ethernet. For the procedure using the V6-CP cable, refer to
the Reference Manual (Operation).
Prerequisites
When screen data is to be transferred for the first time via Ethernet or when the V7 series
has been replaced due to trouble, the server cannot transfer screen data because the
network table has not been transferred to the V7 series. In this case, the following setting
must be made on the Main Menu screen:
- IP address
- Default gateway
- Subnet mask
Note that this is the tentative setting. The port number must be “10000.” When the network
table is transferred from the V-SFT editor, the above data is updated.
• Setting procedure
1. Press the [Ethernet] switch on the Main Menu screen.
2. The Ethernet screen is displayed. (For more information, refer to “Chapter 2
MONITOUCH Operations.”) Set the IP address. If necessary, set the default
gateway and subnet mask. (When attaching the I/F unit to V7, set the connecting
method (10BASE-T/AUI) as well.)
3. When the setting has been completed, press the [Setting Finished] switch. The
Main Menu screen is displayed again.
4. The setting data can be reviewed on the Main Menu screen.
5. Transfer screen data from the server.
Time-Out : 0.50 sec
2002-4 -1 07:23:30
SYSTEM PROG. VER. 1.010
FONT
VER.1.300 / 1.000 / 1.000
ENGLISH
I/F DRV VER.1.310
YOKOGAWA FA-M3
Ethernet
Editor:MJ1
Main Menu V710iTD
System Information
PLC Type : YOKOGAWAFA-M3/FA-M3R(Ethernet)
Comment :
Screen Data
Information
Size : 5783552
SRAM/Clock
Ethernet
Card
Menu
I/O Test
Retry : 3
PORT: 10000
MAC: 0050FF000035
Ethernet Information
PORT: 10000
MAC: 0050FF000035
Trans.Speed : 10BASE-T
Stat. No. : 192.168.1.68
Ethernet Information
Trans.Speed : 10BASE-T
Error : Stop
Stat. No. : 192.168.1.68