Filter
Top Products
2
1. Operation of V7 Main Menu 2-29
MONITOUCH Operations
7. Extended Function Setting
When the [Editor: MJ1] switch on the Main Menu screen is pressed, the following
“Extended Function Setting” screen appears. Set the baud rate to be used when
transferring screen data between the V7 series and a modem.
1. Select the desired baud rate using the [↑] / [↓] switch, and press the [Setting Finished]
switch. (Setting range: 4800, 9600, 19200, 38400, 57600, 115200)
* The function switches and switches on the Main Menu screen are not valid for 15
seconds after the [Setting Finished] switch is pressed.
* When the [Setting Finished] switch is pressed, an AT command is automatically sent to
the modem and the baud rate used between the V7 series and the modem is set.
2. The Main Menu screen is displayed automatically, and “Modem Connect Mode” is
displayed below the [Editor: MJ1] switch.
3. To transfer screen data without a modem, select “Not used” for [Modem Comm. Baud
Rate]. To transfer screen data by connecting the V7 series and the computer via
V6-CP, select “Not used” for [Modem Comm. Baud Rate].
Main Menu
Extended Function Setting
Modem Comm. Baud Rate: Not used
Up Down
Setting
Finished
Up
Down
Setting Value
Pressing the [Editor: MJ1] switch brings up
the “Extended Function Setting” screen.
Pressing the [Setting Finished] switch
moves back to the Main Menu screen.
Editor:MJ1
Retry
:
10
Modem Connect Mode
Ethernet Information
Trans.Speed : 10BAS
E
Stat. No. : 192.16
8
PORT: 10000
MAC: 0050FF000035
Baud Rate : 115200
Editor:MJ1
PORT : 10000
MAC : 050FF000035
Tr
a
s
.S
peed
:
Stat. No. :
10BA
S
E-
192.168.
1