Filter
Top Products
4-10 1. Ethernet
5. Check the IP address, and click [PC->].
6. Data transfer is started.
V-SFT Setting (PLC Type/Communication Parameter)
To enable Ethernet communications on the V7 series, the following setting is required on
the V-SFT editor.
• PLC type setting
• Communication parameter setting
• Network table editing
In this section, the PLC type setting and communication parameter setting are explained.
Connection Example
There are two connecting methods between the V7 series and the PLC.
(A) Connecting to the PLC through RS-232C or RS-485 interface
(B) Connecting to the PLC on the Ethernet
IP address for transfer target
Ethernet
RS-232C
RS-485
run
run
(A)
(B)
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
S
erver
Ethernet-ready PLC
Application