Filter
Top Products
Troubleshooting
Document 800-00919 Rev F 123
02/08
C
Troubleshooting
Problem Possible Solution
No Power • Check power cord connections
• Confirm that there is power at the outlet
No Live Video • Check camera video cable and
connections
• Check monitor video cable and
connections
• Confirm that the camera has power
• Check camera lens settings
• Check CVBS/VGA switch settings
Live Video Very Bright If a cable is attached to the "Loop" connector,
ensure that it is connected to a properly
terminated device.
DVR has stopped recording If hard disk drive is full, you need to either
delete video or set the DVR to the Overwrite
Mode.
DVR displays an error
message stating that the last
recorded image date and
time is later than the current
date and time setting of the
DVR.
The DVR automatically resets the time and
date of the unit, according to the time and date
of the last recorded image.
If this is not the correct time and date, reset the
time and date manually.
If the correct time and date is earlier than the
last recorded image, any video with a later
time and date is lost when resetting the correct
time and date.