Filter
Top Products
Configuration
Document 800-00919 Rev F 45
02/08
Checking the System
1. Highlight System Check in the Main menu and press . The System Check
(Config.) screen appears.
Figure 3-13 System Check (Config.) Screen
2. Highlight the field under the On/Off heading for the desired category and press
to toggle between On and Off. When turned On, the DVR reports a fault
condition if it does not detect any recording or if there is no alarm during the
designated time.
3. Highlight the field under the Interval heading and press . A slide bar appears
allowing you to set the check interval from 1 hour to 30 days.
The Status field displays Good if:
• the DVR is operating according to the user's settings without any problems
• there was recording
OR
• any alarm occurred during the designated time
The Status field displays Bad if there was no recording during the designated time, or
no alarm occurred during the designated time.
Setting Up Alarm Out/Notify
1. Highlight the Alarm Out/Notify tab and press . The System Check Alarm
Out/Notify screen appears.