Filter
Top Products
Configuration
62
Your DVR offers a variety of flexible recording modes. You can set it to:
• record all the time
• record only events
• continue recording after the hard disk drive is full by recording over the oldest
video
• alert you and stop recording when the hard disk is full
Using the Record Mode Setup Screen
From the Main menu, select Record, then highlight Record Mode and press . The
Record Mode Setup screen appears.
Figure 3-32 Record Mode Setup Screen
Table 3-8 Record Mode Setup Screen Options
Option Function
Resolution Highlight the field beside Resolution and press .
Note The maximum recording speed is 30 images per second (25 ips for PAL)
when the resolution is set to Standard. However, when set to High, the
recording speed decreases to 15 images per second (12.5 ips for PAL).
End Of Disk Highlight the field beside End Of Disk and press
to toggle between Stop and Overwrite.
When in the Stop mode, the DVR stops recording
when the hard disk drive is full. When in the Overwrite
mode, the DVR continues recording when the hard
disk drive is full by overwriting the oldest video.
If the DVR is set to the Stop mode, you can set it to
beep or to activate the Alarm Out port when the hard
disk drive is full.
On Disk Full Beep Highlight the field beside On Disk Full Beep and press
to toggle between On and Off.