Filter
Top Products
118
CH01 EXT Ad P1
[ ]
CH00 EXT Ad P1
[ ]
CH00 x y Lv P1
3127 3293 40.0
_
1
4
2
3,5
143
2
Setting Section Pages 45 to 74
When the optional 4-Probe Expansion Board CA-B04 is used
1 Press the key to display the menu se-
lection screen.
2 Press the key to open the PROBE se-
lection screen.
3 Press the key until the desired probe
no. appears.
4 Press the key to confirm the selection.
From the Measurement Preparation section
When performing measurement using Konica Minolta calibration stan-
dard
<Setting/Changing the Target Color> Page 61
1.
Setting/Changing the Target Color by Measurement Page 62
This method can be used for any memory channels
.
HOLD LED
Memory channel
Probe no.
When the optional 4-Probe Expansion Board CA-B04 is used
1 Press the key to display the menu se-
lection screen.
2 Press the key to open the PROBE se-
lection screen.
3 Press the key until the desired probe
no. appears.
4 Press the key to confirm the selection.
Memory channel
Probe no.
1.Press the CH and keys to select the
desired memory channel.
2.Place the measuring probe with the display and
take measurement.
3.Press the HOLD key.
The HOLD LED will light up.
4.Press the key.
5.Press the HOLD key. Measurement will start.
The HOLD LED will light off.
2.
Setting/Changing the Target Color by Entering Values
Page 64
This method can be used for memory channel CH00 only.
1.
Press the CH
and
keys to select CH00.
2.Press the key.
3.Enter the target color (x, y, Lv).
Ten-key ( to , )...
Used to enter values.
Key...............................
The cursor moves in
the order
x → y → Lv → x.
4.Press the key.
Cursor
To the Measurement section Page 75
●To set an ID name : *2 <Setting an ID Name> Page 120
●To use the analog display function: *3 <Setting the Analog Display Range>
Page 120
*1