Filter
Top Products
4343
Measurement Preparation
[P1]
[P3]
[P5]
PQRS
7
TUV
8
WXYZ
MENU
ALPHA
9
GHI
4
JKL
5
MNO LOCK
6
CAL
White
1
ABC
2
DEF
-
SPACE
3
ENTER
Red
0
Green
.
Blue
1
2
3
4
CH00 EXT Ad P1
[ ]
MENU : SELECT
PUSH SPACE KEY
SELECT : PROBE
P1 35881112
SELECT : PROBE
P3 35881113
SELECT : PROBE
P5 35881114
Press the key until
the desired probe no.
appears.
Menu selection screen
PROBE selection screen
When the optional 4-Probe Expansion Board CA-B04 is used
Selecting Probe No.
Measurement will be performed simultaneously with all the connected measuring probes. However, the digital and
analog display sections show only the measurement results taken by the one selected probe.
Follow the procedure given below to select the probe connector No. (P1 to P5) to which the desired measuring
probe is connected.
In this example, a measuring probe is connected to the probe connectors [P1], [P3] and [P5].
[Selecting Method]
1. Press the key.
The LCD display section will switch to the menu selection screen.
2. Press the key to open the PROBE selec-
tion screen.
Each time the key is pressed, the screen will switch
in the order PROBE → SYNC → ID Name input →
RANGE → Measurement Speed → Number of Digits
→ RS232C Baud Rate → PROBE.
3. Press the key to display the probe no. you
want to select.
Each time the key is pressed, the probe no. switches
in the order [P1]→[P3]→[P5]→[P1].
When a High Luminance Measuring Probe(CA-PH02/
05) is connected, "H" will be displayed on the right of
the probe's serial No.
4. Press the key to confirm the selection.
* By default (factory setting), the instrument is set so that [P1] will be
selected automatically when the POWER switch is set to ON. If you
want to change this setting, refer to page 30.