Filter
Top Products
31
Installation/Connection
Changing Method for parameters 4 to
10
For parameters 4 to
10
, switch the LCD display section to the menu selec-
tion screen as explained below.
1. Press the key.
The LCD display section will switch to the menu selection screen.
2. Press the key until the desired screen is displayed.
Each time the key is pressed, the screen will switch in the order
PROBE→SYNC→ID Name input→RANGE→Measurement Speed→
Number of Digits→RS232C Baud Rate→PROBE.
3. Press the key to select the desired setting, and
press the key to confirm the selection.
For the ID name and range, enter the desired settings using the ten-key,
ALPHA and alphabet keys, then press the
key to confirm the set-
tings.
Changing Method for parameter 11 12 13
For the setting method, refer to the page given in the above table.
<About the REMOTE Key>
The REMOTE key should not be pressed unless you are going to commu-
nicate with the PC via RS-232C or USB.
• Pressing the REMOTE key sets the instrument in remote mode, enabling communica-
tion with the PC via RS-232C or USB.
(The REMOTE lamp will light up.) In remote mode, no keys other than the REMOTE
key are effective.
To cancel remote mode, press the REMOTE key again.
MENU : SELECT
PUSH SPACE KEY
SELECT : PROBE
P1 35881112
SELECT : SYNC.
EXT
CH01 EXT Ad P1
[ ]
RANGE x,y Lv
(%) 10 10
SELECT : M-SPD
AUTO
SELECT : DISP.
4 FIGURES
SELECT : BAUD
38400 BPS
Menu selection screen
PROBE selection screen
SYNC selection screen
ID name input screen
RANGE setting screen
Measurement speed selection screen
Number of display digits selection screen
RS-232C baud rate selection screen