Filter
Top Products
1515
Installation/Connection
About CA-100 Compatible Mode
This instrument offers two modes: “CA-100 compatible mode”, that provides data compatibility with measured
data taken by the CRT color analyzer CA-100 and allows communications via RS-232C, and “CA-200” mode, that
allows use of the CA-SDK software supplied with this instrument. “CA-100 compatible mode” has been set prior
to shipment from the factory.
If you have established a CA-100-based communication environment and are going to introduce this instrument,
use “CA-100 compatible mode”.
<CA-100 Compatible Mode>
● Allows control of the instrument using RS-232C commands
same as CA-100.
[Switching Communication Mode]
Switch the mode from CA-100 compatible mode to CA-200 mode or vice versa.
Once a mode is selected by this method, it will remain effective until it is changed by this method.
Set the POWER switch to ON (|) while pressing the REMOTE key.
The REMOTE key must be kept held down for more than two seconds after the power is turned ON.
The mode will switch and the instrument will start up.
The communication mode can be switched from CA-100 compatible mode to CA-200 mode or vice versa
as shown below.
CA-200 mode → CA-100 compatible mode
Display
CA-100 compatible mode → CA-200 mode
Display
REMOTE
CA-100 MODE
REMOTE
CA-200 MODE