Filter
Top Products
2525
Installation/Connection
About Installation
The operating environmental requirements are given in the “Specifications” of this manual. The instrument must
be installed in a place that completely meets these requirements. (Page 114-115)
<Notes on Installation>
● Using the instrument in direct sunshine in midsummer or near a heater will cause a rapid rise in its temperature
resulting in breakdown.
Special care must be taken when handling the instrument in such an environment. In addition, take care not to
allow the vents to become blocked. Do not use the instrument in poorly ventilated areas.
● Do not use the instrument in a place where the temperature changes rapidly, since measured values will be
incorrect.
● The instrument must not be used in areas where there is an excessive amount of dust or where the humidity is
excessively high.
● The instrument must not be used if foreign matter such as water and metal objects enter it, doing so is very
dangerous.
● The AC power cord must not be pulled or bent excessively nor must excessive force be exerted on it. Doing so
may result in wire breakage.
● The AC power cord must not be connected to an AC line on which excessive noise is present.
● If any irregularity or abnormality is found, turn OFF the power immediately, disconnect the AC power cord,
and refer to “Troubleshooting Guide” on page 111.