Filter
Top Products
7
When performing measurement using
Konica Minolta’s calibration standard
Settings Section P. 45-74
This section explains settings that must be made according to measurement method.
The setting method varies with measurement method.
From the Measurement Preparation section
Outline of the Settings Section
Explains measurement method types and settings that must be made.
(Check what settings you need to make.)
Before Making Each Setting
Gives detailed explanations on memory channels common to each setting and target colors.
When performing measurement using
user calibration
When performing measure-
ment in analyzer mode
Setting/Changing the Target Color *1
Explains how to set/change the tar-
get color.
1. Setting/Changing the Target
Color by Measurement
2. Setting/Changing the Target
Color by Entering Values
User Calibration
Gives detailed explanation of user
calibration and explains its execution
method.
(Target color is also set at this time.)
Analyzer Mode
Gives detailed explanation of ana-
lyzer mode and explains how to in-
put the display’s RGB emission char-
acteristic for Analyzer Mode.
(Target color is also set at this time.)
P. 61 P. 50 P. 57
Other Settings
Explains how to set an ID name *2
and analog display range *3.
Settings Checking Method
Explains how to check the set values
and check the probe serial no. used
when the values are set.
P. 66 P. 72
•To set an ID name:
“Setting an ID Name”
(Page 66) *2
•To use the analog display
function:
“Setting the Analog
Display Range” (Page
68) *3
•To change the target color after user
calibration:
“Setting/Changing the Target Color”
(Page 61) *1
•To change the target color
after inputting the display’s
RGB emission characteristic:
“Setting/Changing the Target
Color” (Page 61) *1
To the Measurement section
P. 75-82
Page 46
Page 48