Filter
Top Products
DMA Operations Guide Local Cluster Configuration Procedures
82 Polycom, Inc.
Local Cluster Configuration Procedures
This section describes the following Polycom DMA 7000 system configuration
procedures:
• Add Licenses
• Configure Signaling
• Configure Logging
If you’re performing the initial configuration of your Polycom DMA system,
study “Polycom
®
DMA
™
System Initial Configuration Summary” on page 23
before you continue. Other tasks are required that are described elsewhere.
Add Licenses
Adding licenses to your Polycom DMA system is a two-step process:
• Request a software activation key code for each server.
• Enter the activation key codes into the system.
The procedures below describe the process.
To request a software activation key code for each server
1 Log into the Polycom DMA system as an administrator and go to Admin
> Local Cluster > Licenses.
2 Record the serial number for each Polycom DMA server:
Server A: ____________________________
Server B: ____________________________ (none for single-server system)
3 Go to http://www.polycom.com/activation.
4 If you don’t already have one, register for an account. Then log in.
5 Select Product Activation.
6 In the License Number field, enter the software license number listed on
the first (or only) server’s License Certificate (shipped with the product).
7 In the Serial Number field, enter the first (or only) server’s serial number
(which you recorded in step 2).
8 Click Generate.
9 When the activation key for the first (or only) server appears, record it:
Server A: __________-__________-_________-___________
10 If you have a single-server Polycom DMA system, you’re finished with
this procedure. Continue to the next procedure.