Filter
Top Products
IM 01E20C01-01E
5-3
5. BASIC OPERATING PROCEDURES
Touch SHIFT + key
FR
m
3
/h
: : :
100
3274m
3
FTL
0
F0503-1.EPS
Setting switches
Start:
Display Mode
Entry Mode
The Entry Mode
will be omitted for a
period of 1 minute
when returning from
the Setting Mode to
the Display Mode.
5.2 Display Unit Setting Methods
NOTE
Before changing any settings, be sure to check the corresponding setting details
in Chapter 6: Parameter Description.
5.2.1 Display Mode → Setting Mode
Display Mode will be adopted when the power is turned on, and the Setting Mode can be
activated using the following procedure.
(2 seconds or more)
Select “No”
Press the SET switch while holding down the SHIFT switch.
Display Mode
Entry Mode
Parameter Search Mode
Major Item Parameter
Search Mode
Sub-item Parameter
Search Mode
Parameter
Replacement Mode
Setting modes
F0502.EPS
+
+ +
* The term "mode" is used to refer to a situation
where display and setting are possible.
Select “Yes”
Sample Display: Procedure for moving from Display Mode to Setting Mode
1st line: Actual instantaneous flow rate [FR]
2nd line: Bar graph indicating instantaneous flow
rate
3rd line: Totalized forward flow rate [FTL]
Hold the switch for 2 seconds.
Touch and switches simultaneously.