Filter
Top Products
274
Notes on the LP mode
•When you record a tape in the LP mode on your camcorder, we recommend playing back the tape on
your camcorder. When you playback the tape recorded on another camcorder or VCR, noise may
occur in images or sounds.
•When you record in the LP mode, we recommend using a Sony cassette so that you can get the most
out of your camcorder.
•When you record in the SP and LP modes on one tape or you record some scenes in the LP mode, the
playback picture may be distorted or the time code may not be written properly between scenes.*
2)
•Noise may occur also when you play back on your camcorder tapes recorded in the LP mode on
another camcorder or VCR.*
3)
•When you record a tape in the LP mode on your camcorder, recording is carried out in the
standard 8 mm system.*
3)
Note on AUDIO MODE*
2)
When playing back a tape recorded in the 16-bit mode, you cannot adjust the balance in AUDIO MIX.
Note on dubbing a tape to another VCR*
4)
You cannot select AUDIO MODE for tapes recorded in the Digital8 system. You, however, can select
AUDIO MODE when you dub tapes recorded in the Hi8 /standard 8 mm system to another
VCR using the i.LINK cable.
Notes on ORC setting*
3)
•Each time you eject the cassette, the ORC setting will be cancelled. If necessary, set the setting.
•You cannot use this setting on a tape with the red mark on the cassette exposed.
(i. e. the tape is write-protected)
•When you set ORC TO SET, a non-recorded section of about 0.1 seconds appears on the tape.
However, note that this non-recorded section disappears from the tape when you continue recording
from this section.
•To check if you have already set the ORC setting, select ORC TO SET in the menu settings. “ORC
ON” is displayed if ORC TO SET is already set.
*
1)
Modes on the POWER switch vary depending on models (p. 26).
*
2)
*
3)
*
4)
Changing the menu settings