Filter
Top Products
Unpacking
January 2009 UDA2182 Universal Dual Analyzer Product Manual 9
3 Unpacking, Preparation, and Mounting
3.1 Overview
Introduction
This section contains instructions for unpacking, preparing, and mounting the Analyzer.
Instructions for wiring are provided in Section 4 (power wiring) and Section 7 (input
wiring). Software configuration is described in Section 6.
The UDA2182 Analyzer can be panel, wall, or pipe mounted.
Each unit has (4) 22.22mm [.87"] dia. holes on the bottom of the unit for lead wires and
conduit fittings. The user supplies the conduit fittings.
CAUTION
To avoid damage to the case when connecting to a rigid metallic conduit system, the
conduit hub must be connected to the conduit before the hub is connected to the
enclosure
ATTENTION
When installing the unit, you must select appropriate watertight fittings to insure
watertight integrity.
What’s in this section?
The topics in this section are listed below.
Topic See Page
3.1 Overview 9
3.2 Unpacking and Preparing 10
3.3 Mounting 10