Filter
Top Products
Configuration
January 2009 UDA2182 Universal Dual Analyzer Product Manual 53
6.3 Main Setup Menu
Accessing the Main Menu
Press
Setup
. The main Menu will appear.
Setup
Inputs
Relays
Outputs
Maintenance
Alarms
Logic
PID Control
Math
Communication
Monitors
Auxiliary
Auto Cycling
Setup
Inputs
Relays
Outputs
Maintenance
Alarms
Logic
PID Control*
Math
Communication
Monitors
Auxiliary
Auto Cycling*
Setup
Inputs
Relays
Outputs
Maintenance
Alarms
Logic
PID Control
Math
Communication
Monitors
Auxiliary
Auto Cycling
Setup
Inputs
Relays
Outputs
Alarms
Logic
PID Control*
Math
Monitors
Auxiliary
Auto Cycling*
Variables
Setup
Inputs
Relays
Outputs
Maintenance
Alarms
Logic
PID Control
Math
Communication
Monitors
Auxiliary
Auto Cycling
Setup
Inputs
Relays
Outputs
Maintenance
Alarms
Logic
PID Control*
Math
Communication
Monitors
Auxiliary
Auto Cycling*
Setup
Inputs
Relays
Outputs
Maintenance
Alarms
Logic
PID Control
Math
Communication
Monitors
Auxiliary
Auto Cycling
Setup
Inputs
Relays
Outputs
Alarms
Logic
PID Control*
Math
Monitors
Auxiliary
Auto Cycling*
Variables
*Some item are dependent on the Option selection
Menu Indicators
An upward-pointing arrow indicator above the menu at the left end of the header appears
when there are currently menu items above the screen accessible by moving the cursor
up.
A downward-pointing arrow indicator below the menu at the left end of the status footer
appears when there are currently menu items below the screen accessible by moving the
cursor down.
Use the keys.
Setup Group Overview
Refer to “General Rules for Editing” and Table 6-1 Basic Configuration Procedure to
configure the following Setup Groups.
Inputs Configuration (Table 6-5) – configure:
Input 1 and Input 2 for pH/ORP, pH Preamp, Conductivity, or Dissolved
Oxygen
and associated parameters
Calc Value 1 and 2 (both units of measurement must be the same)
select the
Calculation type [Ratio, sum, etc.], High range and Low range.
Outputs Configuration (Table 6-6) – configure Output 1, 2, or 3 source, % Range
High and Low and associated parameters
Relays Configuration (Table 6-7) – configure Relay 1, Relay 2, Relay 3, and
Relay 4 for Relay Types: Digital Out (Digital Output Relay), Time Prop (Time