Filter
Top Products
129
DVD Multitrack Recorder DV824DVD Multitrack Recorder DV824
DVD Multitrack Recorder DV824DVD Multitrack Recorder DV824
DVD Multitrack Recorder DV824
2) Press the [ENTER/YES] key.
The screen goes down to the editing screen, as shown below.
The frame value of time code flashes.
<Note>:
Only when the TC generator mode is set to "Free Run" and the generator
userbit is set to "<user>", you can edit the userbit value in the same manner as
editing the time code start time value.
If you just view the information and do not make any editing, press the [EXIT/NO] key
to exit the TC SETUP menu.
Only when the TC generator mode is set to "Free Run", "Rec Run" or "24H Run", you can
edit the start time by following the procedure below.
3) Enter the desired time code value (and userbit value), and press the [ENTER/YES] key to
confirm your setting.
Pressing the [CLEAR] key clears the time value to zero.
Use the [MENU] dial (or the alphanumeric keys) to enter a desired value and use the
[SKIP/CURSOR
] keys to move the cursor position.
When the editing screen (as shown on the right above) is shown In the "Rec Run" mode,
pressing the [EXIT/NO] key resets the time code value to "--h--m--s--f".
When “Free Run” is selected.
When “Rec Run” is selected.
<Note>:
In the "Rec Run" mode, time code starts from the edited value when starting
recording a new file.
<Notes>
• Under "LOOKUP GEN TC", the current generator mode is shown (in the screen
example above, "[Run mode]" is shown).
• If no time code is fed to the unit in the "EXT RUN" mode, "<<No EXT TC!>>" is
shown.
• In the "Rec Run" or "24H Run" mode, user bit is not shown.
• In the "Rec Run" mode, the "TC" field shows "--h--m--s--f".