Samsung S3F80JB Universal Remote User Manual


 
S3F80JB RESET
8-17
Table 8-4. Set 1, Bank 1 Register Values After Reset
Address Bit Values After Reset
Register Name Mnemonic
Dec Hex 7 6 5 4 3 2 1 0
LVD Control Register LVDCON 224 E0H – – – – – – – 0
Port 3 [4:5] Control Register P345CON 225 E1H 0 1 0 1 0 0 0 0
Port 4 Control Register (High Byte) P4CONH 226 E2H 1 1 1 1 1 1 1 1
Port 4 Control Register (Low Byte) P4CONL 227 E3H 1 1 1 1 1 1 1 1
Timer 2 Counter Register (High Byte) T2CNTH 228 E4H 0 0 0 0 0 0 0 0
Timer 2 Counter Register (Low Byte) T2CNTL 229 E5H 0 0 0 0 0 0 0 0
Timer 2 Data Register (High Byte) T2DATAH 230 E6H 1 1 1 1 1 1 1 1
Timer 2 Data Register (Low Byte) T2DATAL 231 E7H 1 1 1 1 1 1 1 1
Timer 2 Control Register T2CON 232 E8H 0 0 0 0 0 0 0 0
Comparator Mode Register CMOD 233 E9H 0 0 0 0 0 0 0 0
Comparison Result Register CMPREG 234 EAH 0 0 0 0 0 0 0 0
Comparator Input Selection Register CMPSEL 235 EBH – – – – 0 0 0 0
Flash Memory Sector Address
Register (High Byte)
FMSECH 236 ECH 0 0 0 0 0 0 0 0
Flash Memory Sector Address
Register (Low byte)
FMSECL 237 EDH 0 0 0 0 0 0 0 0
Flash Memory User Programming
Enable Register
FMUSR 238 EEH 0 0 0 0 0 0 0 0
Flash Memory Control Register FMCON 239 EFH 0 0 0 0 – – – 0
NOTES:
1. P345CON will be initialized as “50H” to set P3.4 and P3.5 into open drain output mode after reset operation.
2. S3F80JB has P4CONH, P4CONL and P4CON as port4 control registers. P4CONH and P4CONL will be initialized
as the C-MOS input with pull up mode after reset. On the other hand, P4CON will be initialized as open-drain output
mode. After reset, status of port4 is decided by P345CON.0 bit. So port4 reset status will be initialized as open-drain
output mode.