Filter
Top Products
S3F80JB INTERRUPT STRUCTURE
5-7
ENABLE/DISABLE INTERRUPT INSTRUCTIONS (EI, DI)
Executing the Enable Interrupts (EI) instruction globally enables the interrupt structure. All interrupts are then
serviced as they occur, and according to the established priorities.
NOTE:
The system initialization routine that is executed following a reset must always contain an EI instruction to
globally enable the interrupt structure.
During normal operation, you can execute the DI (Disable Interrupt) instruction at any time to globally disable
interrupt processing. The EI and DI instructions change the value of bit 0 in the SYM register. Although you can
manipulate SYM.0 directly to enable or disable interrupts, we recommend that you use the EI and DI instructions
instead.
SYSTEM-LEVEL INTERRUPT CONTROL REGISTERS
In addition to the control registers for specific interrupt sources, four system-level registers control interrupt
processing:
— The interrupt mask register, IMR, enables (un-masks) or disables (masks) interrupt levels.
— The interrupt priority register, IPR, controls the relative priorities of interrupt levels.
— The interrupt request register, IRQ, contains interrupt pending flags for each interrupt level (as opposed to
each interrupt source).
— The system mode register, SYM, enables or disables global interrupt processing (SYM settings also enable
fast interrupts and control the activity of external interface, if implemented).
Table 5-2. Interrupt Control Register Overview
Control Register ID R/W Function Description
Interrupt Mask Register IMR R/W Bit settings in the IMR register enable or disable interrupt
processing for each of the eight interrupt levels: IRQ0–IRQ7.
Interrupt Priority Register IPR R/W Controls the relative processing priorities of the interrupt levels.
The eight levels of the S3F80JB are organized into three
groups: A, B, and C. Group A is IRQ0 and IRQ1, group B is
IRQ2, IRQ3 and IRQ4, and group C is IRQ5, IRQ6, and IRQ7.
Interrupt Request Register IRQ R This register contains a request pending bit for each interrupt
level.
System Mode Register SYM R/W A dynamic global interrupt processing enables/disables, fast
interrupt processing, and external interface control (an external
memory interface is not implemented in the S3F80JB
microcontroller).