Filter
Top Products
RECORD SET2
English 105
Use the following procedure to set motion sensors on video
from each camera so that alarms can be detected.
(1) Motion sensor setting
Display changes in response to the sensor condition. Settings
are made using the jog dial.
-: Sensor off
A or B: Sensor on
(2) Camera number display
Changes when a [CAMERA SELECT] button is pressed. Use
this item to select the camera for which motion sensors are to
be set up.
(3) Time period
Select an interval set using “TIME PERIOD” (JP.74).
(4) LEVEL
Sets the sensitivity level of the motion sensors.
OFF: No motion sensor has been set.
1 to 10: A motion sensor is set. Lower values correspond to
higher sensitivity levels and vice versa.
(5) MODE
Sets the detection method for the motion sensors. (JP.107)
1 Make timer settings for “TIME PERIOD
A” and “TIME PERIOD B” on the <TIME
PERIOD SET> screen. (JP.74)
2 Press the [MENU] button.
The MENU indicator lights up and the <MAIN MENU> is
displayed.
3 Turn the jog dial to select “2.RECORD
SET” and then turn the shuttle dial
clockwise.
The <RECORD SET> screen is displayed.
4 Turn the jog dial to select “7.ALARM
REC MODE SET” and then turn the
shuttle dial clockwise.
The <ALARM REC MODE SET> screen is displayed.
5 Turn the jog dial to select “MOTION
SENSOR” and then turn the shuttle dial
clockwise.
Setting the motion sensors
CH01 T-1 LEVEL : OFF MODE : A
(1)
(2)
(3)
(4) (5)
MENU
<ALARM REC MODE SET>
ALARM RECORDING : OFF
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : ***
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : SENSOR
MOTION SENSOR ->
<ALARM REC MODE SET>
ALARM RECORDING : ENABLED
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 12.5FPS, DURATION: 20SEC
PRE-ALARM RECORDING : OFF
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : SENSOR
MOTION SENSOR ->
CH01 T-1 LEVEL : OFF MODE : A
The <MOTION SENSOR>
screen is displayed.
The cursor (reverse
highlighting) is displayed at
the top left position.
Cursor can be moved to the
left and right using the jog
dial if a mark indicating such
actions is displayed in the
upper right of the screen.