Filter
Top Products
110 English
RECORD SET2
INTRODUCTION SETTINGS NETWORK
CONTROL
NETWORK
OPERATION
NETWORK
SETTINGS
OTHEROPERATION
z After an alarm duration has ended, the display returns to
the screen prior to the alarm.
z “ALARM PRIORITY” cannot be selected when “MAIN
MON. DISPLAY” is set to “9”, “16” or “NC”.
10 Turn the shuttle dial clockwise.
“NC” flashes.
11 Turn the jog dial to select the “MON.2
DISPLAY” value and then turn the
shuttle dial clockwise.
[Settings] ( indicates default setting)
12 Press the [EXIT/OSD] button.
The setting is completed and the display returns to the normal
screen.
To forcibly cancel an alarm during alarm operation, press the
[CAMERA SELECT] button for the camera with the alarm and
hold it for approximately 3 seconds. Alternatively, connect a
switch between the ALARM RESET terminal and C terminal
(the grounded terminal), and turn on the switch to cancel an
alarm that occurs.
Setting Description
NC
When an alarm is detected, Monitor 2 does
not change.
SWITCH
When a number of alarms occur, the
display switches between the video from
the corresponding cameras, showing each
for one second.
LAST
When a number of alarms occur, the most
recent alarm video is given priority and is
displayed.
FIRST
When a number of alarms occur, only the
video for the first alarm is displayed.
However, if the duration for the first alarm
expires, video for the next alarm is
displayed.
<ALARM OPERATION SET>
ALARM RETRIGGER : ON
MAIN MON. DISPLAY : FULL
ALARM PRIORITY : LAST
MON.2 DISPLAY : NC
<ALARM OPERATION SET>
ALARM RETRIGGER : ON
MAIN MON. DISPLAY : FULL
ALARM PRIORITY : LAST
MON.2 DISPLAY : NC
Canceling an alarm
EXIT/OSD
C
ALARM
RESET