Filter
Top Products
122 English
GENERAL SET3
INTRODUCTION SETTINGS NETWORK
CONTROL
NETWORK
OPERATION
NETWORK
SETTINGS
OTHEROPERATION
This section describes how to initialize the hard disk and
perform mirroring.
The internal hard disk capacity is displayed as DISK 1 and
DISK 2; the hard disk capacity for the expansion unit is
displayed as EX-DISK 1 to 4.
1 Press the [MENU] button.
The MENU indicator lights up and the <MAIN MENU> is
displayed.
2 Turn the jog dial to select “3.GENERAL
SET” and then turn the shuttle dial
clockwise.
The <GENERAL SET> screen is displayed.
3 Turn the jog dial to select “5.HDD SET”
and then turn the shuttle dial clockwise.
The <HDD SET> screen is displayed.
4 Then turn the shuttle dial clockwise.
The <WARNING> screen is displayed. “NO” flashes.
5 Turn the jog dial to select “YES” and
then turn the shuttle dial clockwise.
The “HDD INITIALIZING !” screen is displayed and the hard
disk is initialized.
When initialization is completed, the display returns to the
<HDD SET> screen.
6 Press the [EXIT/OSD] button.
The setting is completed and the display returns to the normal
screen.
Set mirroring when two hard disks are built-in or when hard
disk expansion has been carried out and even numbered hard
disks are set.
When mirroring has been set, the same image can be
recorded to two hard disks.
If there is a recording error, the <HDD SET> screen can be
used to select another hard disk to read the data. (JP.124)
When mirroring is set for hard disks of different capacities,
mirroring occurs on the hard disk with the smaller capacity.
z Once mirroring is set, configurable recording rates are
limited for use in normal recording, pre-alarm recording
and program recording (including alarm program
recording).
z When using a RAID unit for mirroring, set “MIRRORING”
for the DVR unit to “OFF”.
1 Press the [MENU] button.
The MENU indicator lights up and the <MAIN MENU> is
displayed.
2 Turn the jog dial to select “3.GENERAL
SET”and then turn the shuttle dial
clockwise.
The <GENERAL SET> screen is displayed.
Hard disk initialization and mirroring
Initializing the hard disk
MENU
<HDD SET>
DISK 1 : 250GB DISK 2 : 250GB
DISK INITIALIZE ->
CAUTION : ALL RECORDING WILL BE ERASED!
MIRRORING : OFF
PLAYBACK DRIVE : ***
<WARNING>
THIS CHANGE WILL INITIALIZE THE DISK.
ALL RECORDING WILL BE ERASED.
ARE YOU SURE ?
NO
CHANGE:JOG SET:SHUTTLE
Setting mirroring
HDD INITIALIZING !
EXIT/OSD
MENU