Filter
Top Products
D-160 Owner's Manual (MIDI sync function)
118
Setup of D-160
1
. Because the MIDI clock and song position pointer will be output from the D-160, set the SETUP
mode "MIDI sync signal output setting" to "CLK."
* Initial setting: CLK
* Permissible setting: CLK (MIDI clock and song position pointer:"CLK") / MTC (MIDI time code: "MTC")
/ Off (No output of MIDI sync signal)
* This item can be setup for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "150", SETUP mode "2-8. MIDI sync signal output setting" for correct
operating procedures.
2
. The meter in the desired bar can be set by "Time signature setting" of the SETUP mode.
* Initial setting: 001 bar, 4/4 signature.
* Permissible bar setting: 001~999
* Permissible meter setting: 1/4, 2/4, 3/4, 4/4, 5/4, 1/8, 3/8, 5/8, 6/8, 7/8, 8/8, -- -- (Elimination of signature)
* Permissible setting of maximum number of points: 64 points
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "143", SETUP mode "2-2. Time Signature Setting" for operating procedure.
3
. Tempo in the desired bar can be set by "Tempo setting" of the SETUP mode.
Tempo map is made in steps 2 and 3.
* Initial setting: 001 bar, 1st meter, Tempo120.
* Permissible bar setting: Follows the previous "Setup of the time signature."
* Permissible signature setting: Follows the previous "Setup of the time signature."
* Permissible setting of tempo: Quarter note=30~250 .... (Tempo elimination)
* Permissible setting of maximum number of points: 64 points
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "145", SETUP mode "2-3. Tempo Setting" for operating procedure.
4
. Set the SETUP mode "Metronome setting" to ON if click sound is to be output according to the
setup tempo map.
* Initial setting: Off
* Permissible setup item: Off, On
* This item can be set for each program.
* The setting can be saved/loaded as song data.
* This setting will be held even though power is switched OFF.
# Refer to page "148", SETUP mode "2-6. Metronome setting" for operating procedure.
5
. Press the DISP SEL key while pressing the EXECUTE/YES key, and then change the time base
display to BAR/BEAT/CLK.
Confirming the MIDI clock sync
During recording and at playback following the recording, the time base (BAR/
BEAT/CLK) is displayed in accordance to the setup tempo map, and the MIDI clock
and song position pointer is also output.
Confirm that the travel position (BAR/BEAT/CLK) of the D-160 and the travel
position of the synchronized MIDI sequencer are matched.