Filter
Top Products
D-160 Owner's Manual (Names and Functions)
17
Disk space (remain).
When time base is "MTC", the
MTC or LTC time that is input will
be displayed.(at installed Model
8345)
The current position
18. Display Select key [DISP SEL]
This key is used to change the display mode. Pressing this key repeatedly will change the
display mode as follows:
* Refer to pages "26" and "32" for more information about the REMAIN.
Pressing this key while holding down the EXECUTE/YES key will switch the Time Base (*)
as follows. The Time Base can be set when the display shows the recorder's current
position or the available disk space (REMAIN).
ABS (Absolute Time) BAR/BEAT/CLK MTC (MIDI Time Code)
(*) Time Base:
The D-160 uses time display (ABS or MTC) or Bar/Beat/Clock display to indicate the current
position of the recorder section. These displays are called "Time Base." ABS (Absolute Time)
shows the absolute time of the disk, and MTC (MIDI Timecode) shows the relative time obtained
by adding an MTC offset value to the ABS value. Bar/Beat/Clock (BAR/BEAT/CLK) indicates a
position within a piece of music and conforms to the MIDI clock and Song Position Pointers
created on the internal Tempo Map. The tune will be displayed up to 999 bars.
* Refer to pages "38" and "145" for more information about MTC and the internal Tempo
Map.
19. Execute/Yes key [EXECUTE/YES]
Press this key to execute the operation when you edit data on the hard disk using the
edit functions such as Paste and Erase, when you put the D-160 into SETUP mode, or
when you set the parameters in the SETUP menu.
Pressing the DISP SEL key while holding down the EXECUTE/YES key allows you to select
the Time Base. (Refer to the explanation about the DISP SEL key.)
* Refer to page "85" for more information about using this key for the Paste or Erase operation.
* Refer to page "137" for more information about using this key in SETUP mode.
20. Exit key/No key [EXIT/NO]
The opposite of the EXECUTE/YES key, this key is used to stop the operation.
* Refer to page "85" for more information about using this key for the Paste or Erase operation.
* Refer to page "137" for more information about using this key in SETUP mode.
21. Recall key [RECALL]
Press this key to recall the stored time value (or Bar/Beat/Clock value).
Pressing this key, and then one of the following keys will display the data stored at the
key you pressed, and you will be able to edit the data.
RECALL key -> CLIPBOARD IN key The Clipboard In point is recalled and the D-160 enters the edit mode.
RECALL key -> CLIPBOARD OUT key The Clipboard Out point is recalled and the D-160 enters the edit mode.
RECALL key -> AUTO PUNCH IN key The Auto Punch In point is recalled and the D-160 enters the edit mode.
RECALL key -> AUTO PUNCH OUT key The Auto Punch Out point is recalled and the D-160 enters the edit mode.
RECALL key -> AUTO RTN START key The Auto Return Start point is recalled and the D-160 enters the edit mode.
RECALL key -> AUTO RTN END key The Auto Return End point is recalled and the D-160 enters the edit mode.
RECALL key -> LOCATE key The Locate key data is recalled and the D-160 enters the edit mode.
To exit edit mode, press the EXIT/NO key, DISP SEL key, or STOP button.
The Setup mode display
(SETUP is blink) and title
display