Filter
Top Products
D-160 Owner's Manual (Recording /Playback)
48
POWER
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/167/156/145/134/123/112/101/9
RECORD TRACK
HD ACCESSLOCKED MTC IN
ENDIN OUTSTART
AUTO PUNCH
AUTO PLAY IN OUT
AUTO RTN
CLIPBOARD
PASTEMOVECOPY
AUTO RTN
ERASE UNDO REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/ STORE RECALL
TIME BASE SEL
TAKE
REHEARSAL
LOCATEPUNCH
F FWDREWINDPLAYSTOPRECORD
VARI PITCH
LOCATE ABS END
2. Default setting on the D-160
Before you start operating the D-160 or proceed to the next step, you may want to
arrange the controls and switches to restore the initial setting so that you will not,
for example, erase important data on a track by using incorrect settings.
In this manual, this procedure is called "setting defaults." For default settings, the
controls and switches should be arranged as shown in the figure below.
Make it a rule to return to these default settings before you proceed to a new step.
The LED of the SHIFT key is off.
The STORE key and the
RECALL keys are "OFF." (The
STORE/RECALL LEDs are off.)
Turning off the Vari-pitch function.
(The LED is turned off.)
Turn all the RECORD TRACK
select keys to "SAFE." (Track
indication is turned off.)
The STOP button LED is lit.
The display Time Base is set to ABS
TIME, and Program P1 is selected.
Auto Return/Auto Play mode is "OFF." (The
AUTO RTN/AUTO PLAY LEDs are off.)
Auto Punch mode is "OFF." (The
REHEARSAL/TAKE LEDs are off.)
Outline of the Initial Settings:
* Turn all the RECORD TRACK select keys to "SAFE." (Track indication is turned off.)
* Auto Return/Auto Play mode is "OFF." (The AUTO RTN/AUTO PLAY LEDs are off.)
* Auto Punch mode is "OFF." (The REHEARSAL/TAKE LEDs are off.)
* The STOP button LED is lit.
* The STORE key and the RECALL keys are "OFF." (The STORE/RECALL LEDs are off.)
* "Rec Protect?" is "Off" selected in Setup mode.
* "Digi. In?" is assigned to "L: - -, R: - -" in Setup mode.
* "Slave Mode?" is "Off" selected in Setup mode.
* Setting a Program for recording/playback (See 2-1, 2-2, 2-3.)
* Setting a sampling rate for recording/playback (See 2-4.)
* Turning off the Vari-pitch function. (The LED is turned off.)
* The LED of the SHIFT key is off.
When the Recording Enabled/Disabled parameter in the Setup mode is set to "DISABLE
rEc," pressing the RECORD button and the PLAY button will not start recording, and
the unit will display "DISABLE rEc" on the panel. Be sure to set the mode to "EnAbLE
rEc" to enable the recording function.
* "FORMAT FIRST". You need to format the internal hard disk prior to start recording
if a brand new hard disk drive has been installed. Refer to the explanation of the
"Disk Format?" menu in the Setup mode. We recommend that you format the hard
disk as often as possible before you start fresh recording on it.
However, remember that the format process will erase all of the recorded song
data.