Filter
Top Products
D-160 Owner's Manual (Punch In/Out)
77
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/167/156/145/134/123/112/101/9
RECORD TRACK
HD ACCESSLOCKED MTC IN
ENDIN OUTSTART
AUTO PUNCH
AUTO PLAY IN OUT
AUTO RTN
CLIPBOARD
PASTEMOVECOPY
AUTO RTN
ERASE UNDO REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/ STORE RECALL
TIME BASE SEL
TAKE
REHEARSAL
LOCATEPUNCH
F FWDREWINDPLAYSTOPRECORD
VARI PITCH
LOCATE ABS END
5. Press the HOLD/> key to enter edit mode.
Storing the Punch Out point
5, 6
7
6
8
6. Press the HOLD/> key or turn the SHUTTLE dial to select the digit you wish to
edit, then use the JOG dial to change the time value.
For example, setup the Auto Punch Out point to "3 minutes, 35 seconds, 15
frames".
7. Press the STORE key. (The STORE LED will light up.)
8. Press the AUTO PUNCH OUT key.
The specified time value will be stored as a Punch Out point, and the STORE LED
will go off.
* To check the stored Punch In/Out point, press the RECALL key, and then press
the AUTO PUNCH IN key and/or the AUTO PUNCH OUT key.
Alternatively, press the AUTO PUNCH IN/AUTO PUNCH OUT key.
The display will show the stored time value.
<Note>
You cannot set the Punch Out point before the Punch In point location.
If the Punch Out point precedes the Punch In point and you try to "punch in,"
the message "Void Out Point!" appears on the screen immediately after you press
the AUTO PUNCH key, indicating that the time value of the Punch Out point is
inappropriate. Be sure to specify a larger value for the Punch Out point than for
the Punch In point.
<Hints>
If “ Resolution” menu (Bar/Beat Resolution mode) has been turned on in the
Setup mode when the “BAR/BEAT/CLK” Time Based is being used, press the
HOLD/> key or the STORE key to hold the current bar/beat clock value on the
display, and you can round off the clock value to “00” (that is, to a bar/beat
value). This function is useful when you wish to use the memory data in beat
steps.
* Refer to page "*160" for more information on " Resolution" menu in Setup
mode.