Filter
Top Products
D-160 Owner's Manual (Edit function)
86
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/167/156/145/134/123/112/101/9
RECORD TRACK
HD ACCESSLOCKED MTC IN
ENDIN OUTSTART
AUTO PUNCH
AUTO PLAY IN OUT
AUTO RTN
CLIPBOARD
PASTEMOVECOPY
AUTO RTN
ERASE UNDO REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/ STORE RECALL
TIME BASE SEL
TAKE
REHEARSAL
LOCATEPUNCH
F FWDREWINDPLAYSTOPRECORD
VARI PITCH
LOCATE ABS END
1. Copy & Paste
The Copy & Paste functions use the clipboard of the D-160, allowing you
to copy sound data and paste it to the specified area. The copied data
remains on the clipboard after you paste it, and you can paste the same
data as many times as you want to different places. The Copy & Paste
functions can reference any one of the following time bases: ABS time,
MTC time, MIDI Bar/Beat/Clock.
* To perform the Copy operation, you first need to set the start point (Clipboard In point) and the
end point (Clipboard Out point) of the copied data and the copy source track.
To perform the Paste operation, you need to set the start point (Auto Punch In point) and the
paste destination point.
Entering and storing the CLIPBOARD IN point
1. Press the RECALL key, and then the CLIPBOARD IN key (or press only the
CLIPBOARD IN key). The D-160 will enter the edit mode.
2. Move the cursor to the digit you wish to change using the HOLD/> key or the
SHUTTLE dial, and change the value using the JOG dial.
7
2, 5
1, 3
4, 6
3, 6
1, 4
8
1-1. Copying
First, you need to specify the area to be copied (using the Clipboard In/
Out points and copy track).
* The following procedure is based on data with the ABS Time Base.
To change the Time Base to MTC or MIDI BAR/BEAT/CLK, press the DISP SEL key while
pressing and holding down the EXECUTE/YES key.
* Before you start work, restore the default settings on the D-160.
* Do not change Programs or sampling rates until a session is complete.
<Note-1>
The data on the Clipboard will be replaced by new data each time you press the COPY
key of the MOVE key.
<Note-2>
If pasted data overlaps the source data, the content of the source data will be altered.