Filter
Top Products
D-160 Owner's manual (SETUP mode)
171
So, P1 in the internal IDE drive will be saved as S1, P2 as S2, etc. All the programs will be saved in
the same way.
When the D-160 has finished saving song data, it will display “COMPLETED!” and then return to
the normal time base display.
2-24. Formatting IDE/SCSI disk (“Disk Format?”)
When you format or initialize the internal hard disk or externally connected SCSI device,
use this “Disk Format?” menu. If the formatting has been completed, all the recorded
song data will be wiped off completely and the hard disk setting will go back to the initial
factory setting. You need to format a brand new IDE hard disk or SCSI disk before you
start using them.
* See page "39" for details of the Removable Hard disk Cartridge and the replacing Hard disk.
* See page "108" for details of the Handling SCSI disk.
1. Press the DISP SEL key and choose the flashing SETUP mode on the display.
Then, press the EXECUTE/YES key. The SETUP display will stop flashing.
2. With the JOG dial, choose “Disk Format?”.
The “?” display will start flashing. The display will also show the current setting.
3. Press the EXECUTE/YES key.
The current setting will start flashing which indicates it is ready to change setting.
44.1kHz
SETUP
91011121314151687654321
FORMAT
42
OL
0
30
24
18
12
9
6
3
∞
_
4. With the JOG dial, choose the “IDE” or “SCSI” you want.
5. Press EXECUTE/YES key after choosing the setting you want.
The display will show the drive you have chosen. Also, the D-160 will ask you whether you want
to proceed with formatting by displaying the message “SURE?”.
* If you want to cancel the format, press the EXIT/NO key at this stage. If you proceed with
the operation described in step 6 below, you will not be able to stop formatting.
6. If you really want to format, press the EXECUTE/YES key.
If you have chosen “IDE”, the format process will start immediately. The display will start showing
“REMAIN” and the count down memory space display (MB) indicating how long the formatting
process is going take.
Warning
Once the formatting starts, there is no way to stop it. Even the EXIT/NO key or STOP
button won’t help you! If you don’t want to lose the recorded data, never press the
EXECUTE/YES key at this stage.
If you have chosen “SCSI”, the formatting process will still not start. But instead, the display will
show the Format Type which the D-160 has automatically measured on the externally connected
SCSI device.
We recommend you format the disk with this Format Type. However, you can also change the
Format Type with the JOG dial at this stage.
Press the EXECUTE/ YES key after you have chosen the Format type you want.
Now the format process on the SCSI will start.
7. When the format finishes, the display will show “COMPLETED!” in either case.
8. Press the STOP button or EXIT/NO key to quit the SETUP mode and return to the normal time
base display.