Filter
Top Products
D-160 Owner's Manual (Locate function)
70
AUTO RTN START point
LOCATE
PLAY BACK
AUTO RTN END point
PLAY BACK
AUTO PUNCH IN key -> LOCATE key
AUTO PUNCH IN key -> LOCATE key
LOCATE
LOCATE
AUTO PUNCH IN point
3. Auto Play mode
Turn the Auto Play mode on before using the Direct Locate function, and the D-160 will
automatically start playback from the located point .
The diagram below illustrates this operation.
To turn Auto Play mode on, press the AUTO PLAY/AUTO RTN key so that the AUTO PLAY
LED will light up. To cancel this mode, press the AUTO PLAY/AUTO RTN key again so that
the AUTO PLAY LED will go off.
* Refer to page "15" "Names and Functions" for instructions on using the AUTO PLAY
and AUTO RTN keys.
LOCATE point
You can set the preroll point within a range
of 0 to 10 seconds (Refer to page "149"
for details.)
STOP point
You can set the preroll point within a range
of 0 to 10 seconds (Refer to page "149"
for details.)
4. Auto Return mode
To turn Auto Return mode on, press the AUTO PLAY/AUTO RTN key so that the
AUTO RTN LED will light up.
To use the Auto Return function, first you need to specify the Auto Return Start
point and Auto Return End point.
As shown in the diagram below, the D-160 will play back data to the Auto Return
End point, then automatically locate the Auto Return Start point, and then stop.
<Note>
The start point will not be located after the AUTO RTN END point is reached when
the D-160 is in record mode.