Filter
Top Products
D-160 Owner's Manual (Names and Functions)
13
1
2
345
6
7
Names and Functions
<Front Panel (with the detachable controller removed)>
1. Detachable remote controller connector
The detachable remote controller is connected here.
You can remove the controller. Connect the optional extension cable (Model 8551) to
extend the distance.
* Refer to page "44" for information on extending the detachable remote controller connection.
2. Power switch
This switch turns the main power to the D-160 on/off.
<WARNING !>
Before turning the power off to the D-160, first quit the Setup mode and make sure that the
recorder section is stopped. Especially, never attempt to turn off the power to the unit while the
hard disk is accessing data (the HD ACCESS LED is lit or flashing).
Otherwise, not only will you lose recorded data, you may damage to the unit.
3. Controller mount
The detachable remote controller is mounted on the front panel.
4. Hard disk access LED
This LED lights up or blinks when the hard disk is writing or reading data. (Same as the
HD ACCESS LED on the detachable remote controller.)
5. Hard disk power LED
This LED lights up if the hard disk operates correctly when you turn the power on to the
unit. If the Lock key is unlocked, the power to the hard disk will not be turned on, and
the LED will not light up.
6. Removable hard disk cartridge slot
This slot is used to insert a removable hard disk cartridge. This system allows you to
replace the hard disk easily.
* Refer to page "41" for more information on how to replace the removable hard disk cartridge.
<Note>
This slot is covered by a dust-proof panel when the unit is shipped from the factory.
Remove this panel in order to insert a cartridge.
POWER
D-160
DIGITAL MULTITRACK RECORDER