Filter
Top Products
D-160 Owner's Manual (Locate function)
73
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/167/156/145/134/123/112/101/9
RECORD TRACK
HD ACCESSLOCKED MTC IN
ENDIN OUTSTART
AUTO PUNCH
AUTO PLAY IN OUT
AUTO RTN
CLIPBOARD
PASTEMOVECOPY
AUTO RTN
ERASE UNDO REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/ STORE RECALL
TIME BASE SEL
TAKE
REHEARSAL
LOCATEPUNCH
F FWDREWINDPLAYSTOPRECORD
VARI PITCH
LOCATE ABS END
Changing the stored Start / End points
3
1, 3
1
2
1. Press the RECALL key, and then the AUTO RTN START key or AUTO RUN END
key. (As a short-cut, you can press the AUTO RTN START key or AUTO RTN
END key directly.)
The display will show the time value stored at the key, and the unit will enter
the edit mode.
2. Move the cursor to the time value (bar) using the HOLD/> key or SHUTTLE dial,
and use the JOG dial to change the value.
3. Press the STORE key, then press the AUTO RTN START key or AUTO RTN END
key.
The edited time value will be stored as the Start point or End point.
<Hints>
If " Resolution?" menu (bar/beat resolution mode) has been turned on in the Setup
mode when the "BAR/BEAT/CLK" Time Based is being used, press the HOLD/> key or
the STORE key to hold the current bar/beat clock value on the display, and you can
round off the clock value to "00" (that is, to a bar/beat value).
This function is useful when you wish to use the memory data in beat steps.
Refer to page "160" for more information on Resolution menu in Setup mode.
<Note>
Pay attention to the location of the Start and End points. If you have set a larger
value to the Start point than the End point while both Auto Return mode and Auto
Play mode are on, the D-160 will jump to the Start point and continue to play the
rest of the data after playing to the End point (which is located before the Start
point).
Therefore, the repeat operation (explained later) will not be carried out correctly).
The Auto Return mode is effective only when the unit is in play mode.