Filter
Top Products
D-160 Owner's Manual (Punch In/Out)
84
2-3. Undo/Redo of Manual Punch In/Out
* If you press the UNDO key after performing the manual punch in/out operation, the original
sound recorded prior to auto punch in/out will be restored.
* If you press the REDO key after undoing the manual punch in/out operation, the manual punch
in/out data will be restored.
<Note>
You can use the undo/redo functions while the D-160 is in stop mode.
Under the following circumstances, you will be unable to use the undo/redo functions;
1. If you make a new recording,
2. If you make a new edit (copy & paste, move & paste, or erase),
3. If the Auto Punch In point was passed in play or record mode while Auto Punch
mode was on, or
4. If you turned off the power to the D-160, then turned it back on.
5. If you use the Program Change function.
<Note>
Once you perform Punch In/Out recording using a footswitch, you need to stop
the D-160 before performing the next Punch In/Out take.
<Hints>
Besides the foot switch, you can also use the PLAY button and RECORD
button for Manual Punch In/Out recording. (Please note that you can
use these buttons only once.)
11
11
1. Start playing back from a point just before the punch in point.
22
22
2. At the punch in point, press the RECORD button while holding down the
PLAY button. (Punch In)
33
33
3. At the punch out point, press only the PLAY button. (Punch Out)
* You can also rehearse if you "press only the RECORD button" instead
of steps 2 and 3 described above.
<Caution after Punch Out>
At "Take" of punch out, the punch-in recording track will not immediately enter
the repro monitor mode from the input monitor mode but enter the repro monitor
mode about two seconds after mute playback.
This is a functional feature of D-160 and not a malfunction.