Filter
Top Products
D-160 Owner's Manual (Names and Functions)
27
At this time if you press the DISP SEL key, the Disk Remain display will appear. (Both
recordable time and hard disk capacity remaining will be converted to mono track and
expressed in time and megabites.)
DISK REMAIN display
If "BAR/BEAT/CLK" is selected for the timebase (explained later), the DISK REMAIN
indication will show a value (in terms of the number of measures) calculated based on the
last beat/tempo data on the tempo map of the recorded song.
When you press the DISP SEL key again, the Setup mode display will appear.
At this time, the D-160 has not entered the Setup mode. To put the D-160 into the Setup
mode, press the EXECUTE/YES key. After pressing the EXECUTE/YES key, if you wish to go
back to the previous status, press the EXIT/NO key.
Setup mode display ("SETUP" indication is flashing)
44.1kHz
SETUP
91011121314151687654321
42
OL
0
30
24
18
12
9
6
3
∞
_
If you press the DISP SEL key again, the screen will return to the "ABS TIME" display.
4. Switching the Time Base display using the EXECUTE/YES key and
DISP SEL key
When the screen is showing the ABS TIME or REMAIN display, if you press the DISP SEL key
repeatedly while holding down the EXECUTE/YES key, the TIME BASE display will change
cyclically. You can select one of the following Time Base displays.
ABS (Absolute Time)
BAR/BEAT/CLK (Bar/Beat/Clock)
MTC (MIDI Timecode)
44.1kHz
REMAIN
91011121314151687654321
42
OL
0
30
24
18
12
9
6
3
∞
_
44.1kHz
ABS
91011121314151687654321
42
OL
0
30
24
18
12
9
6
3
∞
_
44.1kHz
SIGNATURE
91011121314151687654321
42
OL
0
30
24
18
12
9
6
3
∞
_
44.1kHz
MTC
91011121314151687654321
42
OL
0
30
24
18
12
9
6
3
∞
_