Filter
Top Products
D-160 Owner's manual (SETUP mode)
145
* Press either the STOP button or EXIT/NO key to return from the second step to the first
or to quit SETUP mode. The menu will go backwards each time you press either key so
that you can correct the setting, choose some other SETUP mode or eventually return to the
normal time base display.
2-3. Tempo Setting ("Tempo Map Set?")
This mode sets up the tempo on a song. The way it sets this up is, for example, for the
tempo to become 150 bpm at the 3rd beat in the 12th bar.
The tempo setting and time signature in the previous section make up a tempo map.
After the tempo map has been calculated by completing the tempo and time signature
setting, the D-160 will be able to handle "BAR /BEAT/CLOCK" and the metronome
function. You need to set up the tempo and time signature to generate the MIDI Clock &
Song Position Pointer.
* Refer to page "117" for details of "MIDI Clock Synchronization".
44.1kHz
SETUP
91011121314151687654321
TEMPO
42
OL
0
30
24
18
12
9
6
3
∞
_
<Note>
The D-160 will still run the time counter in PLAY mode even after the ABS END. Thus, it will
continue generating the MIDI Clock & Song Position Pointer even if you have not recorded
anything, provided a tempo map has been set up.
* Initial Setting: 001Bar 1st Beat 120 bpm
* Bar to register: Follows to the time signature setting
* Beat to register : Follows to the time signature setting
* Available tempo : 30 ~ 250, - - (Delete)
* Maximum setting points : 64
* The setting is applicable song by song.
* The setting can be saved or loaded as a part of the song data
* The setting is memorized even when the power is off.
*
Make sure you choose the right program before setting this mode.
1. Press the DISP SEL key and choose the flashing SETUP mode on the display.
Then, press the EXECUTE/YES key. The SETUP display will stop flashing.
2. Choose "Tempo Map Set?" with the JOG dial. The "?" display will start flashing.
3. Press the EXECUTE/YES key.
The D-160 will display "TEMPO" and last recalled bar number with its tempo setting which is
already registered. In the case of the initial setting, because only the first bar, first beat is registered
with a 120 bpm, it will show "001 bar ,1 • =120 ".
Tempo Setting Check
4. Turn the JOG dial when the D-160 displays "TEMPO".
If there are some setting changes registered in a song, you can see the next set up point by
rotating the JOG dial clockwise.("*** bar * , =***)
If you turn the JOG dial fully clockwise, "- - BAR - - , = - -" will be displayed.
This means there is no more tempo changing points registered.
<Note>
The D-160 counts a beat with the last registered tempo, i.e. one bar before the "- - bar - - ,
= - -" . In the case of the initial setting, because only the first beat of first bar is registered
with a 120bpm, the beat counts with a 120bpm until the end unless you register a different
tempo after the second beat of first bar.