Filter
Top Products
D-160 Owner's Manual (Edit function)
96
3. Erase
There are three ways to erase data. Make sure that you learn the difference ways to erase
to avoid mistakes.
Erasing data for a specific part between ABS 0 and ABS END:
You can erase data (make silence) from the Auto Punch In point up to the Auto Punch Out
point between ABS 0 - ABS END. You may specify a mono track, multiple tracks, or all 16 tracks
for the erase operation. As shown in the diagram below, this operation erases data for any
specified part between ABS 0 and ABS END. But, the ABS END position will not be affected.
The REMAIN value (available recording time based on a single mono track) will increase by
the amount you erase.
Erasing specific Program data (Program Erase):
This function enables you to erase data entirety from a selected program and return the
initial settings of this program to its initial figures.
Unlike the other two erase functions, for Program Erase you do not need to specify tracks or
set the Auto Punch In/Out points. Executing this erase function will erase all data recorded in
the selected Program. The ABS time and the REMAIN value will return to their default settings.
Use caution, since you cannot UNDO this erase operation.
Erasing all data from a specified point up to ABS END:
You may erase data from a specified point (Auto Punch In point) up to ABS END of a selected
Program. You need to specify the erase start point as the Auto Punch In point, and the ABS
END point (the end point of recording) or any point (time) after the ABS END point as the Auto
Punch Out point. You may specify a mono track, multiple tracks, or all 16 tracks for the erase
operation. If you specify all tracks, the ABS END point of the selected Program will move back
and the REMAIN value will increase. If you specify any other track combination, the ABS END
point will not move; only the REMAIN value will increase.
Any Track
AUTO PUNCH IN point
ABS 0
Any Track
Non recorded area
ABS END
ABS END
Erase
AUTO PUNCH OUT point
Any Track
AUTO PUNCH IN point
AUTO PUNCH OUT point
ABS END
ABS 0
Any Track
Erase
No sound area
ABS END
ABS 0
Program Erase
ABS 0 = ABS END
Recorded area
All data recorded in
a random program.
Any Program