Filter
Top Products
D-160 Owner's Manual (Recording /Playback)
59
3-6. Ping-pong recording
This section explains how to perform ping-pong recording.
Ping-pong recording enables you to combine multiple recorded tracks and copy
them to an empty track. You can then overdub additional sounds onto the
previously-recorded tracks, adding instrumentation or musical parts to your
recording.
Selecting a recording track
1
. Press the RECORD TRACK select keys 9 and 10 to "READY" Tracks 9 and 10.
Level adjustment/Rehearsal
2
. Press the RECORD button once. (The RECORD LED will blink.)
Tracks 9 and 10 enter input monitoring status.
3
. Press the PLAY button to start playback.
Use the mixer to send the signal in Tracks 1-6 to Tracks 9 and 10 and adjust the recording
level.
4
. After rehearsal is complete, locate the beginning of the program (ABS 0).
Actual ping-pong recording
5
. Press the RECORD button while pressing and holding down the PLAY button to start
ping-pong recording.
* In this example, we are going to ping-pong Tracks 1 through 6 to Tracks 9 and 10.
Since effects cannot be applied to each sound individually after ping-pong recording, we need
to apply effects here on the mixer and record the effect sound to Tracks 9 and 10.
* Set the D-160 to the default setting.
* Check the Program selection and the sampling rate setting. Do not change these settings until
this session is complete.
Track 15
Track 16
Track 10
Track 11
Track 12
Track 13
Track 9
Track 8
Track 3
Track 4
Track 5
Track 6
Track 7
Track 2
Track 14
Track 1
Ping-pong recording
(Original signal and
Effected signal)