Filter
Top Products
D-160 Owner's Manual (MMC/FEX List/Maintenance/Specifications)
183
14 07 (<fs rate>): Fs rate set command
The command for setting the current program fs (sampling frequency) at the figure
indicated by <fs rate>.
14 08 (<time base>): Time base set command
The command for setting the current program time base of this equipment to that indicated
by <time base>.
The Status Request Command
22 21: loop operation status request
The command inquiring the loop operation mode setup status.
D-160 will reply with "32 21 (<loop op.mode=12>)."
22 22: loop on/off status request
The command inquiring the loop on/off (=ON/OFF of AUTO RETURN) setup status.
D-160 will reply with "32 22 (<on/off>)."
22 28: post locate status request
The command inquiring the post locate mode (ON/OFF of AUTO PLAY) setup status.
D-160 will reply with "32 28 (<post locate mode>)".
22 2D: auto rec status request
The command inquiring the auto rec mode setup status and this is replied by "32 2D
(<edit message>)." Reply from D-160 against this status request will be either one of the
following:
<edit message> =05: Possible to undo rehearsal mode.
=06: Possible to undo take mode.
=72: off
22 41: lock status request
The command inquiring the slave on/off setup status and the lock status.
D-160 will reply with "32 41 (<lock status>)."
22 42 : lock mode status request
The command for inquiring the lock mode setup status and this is replied with "32 42
<lock mode>."
22 45: copy clip status request
The command inquiring the clipboard condition. If there is a copy paste data in the
clipboard, D-160 will reply with "32 45 (<edit message=01>)." If data in the clipboard is
for move paste or there is no valid data in it, it will reply will "32 45 (<edit message=14
(void data)>)."
22 46: copy paste status request
The command inquiring execution status of copy paste editing.
When this command is received, D-160 will reply with either "32 46 (<edit message=02>
<mmc time>)" or "32 46 (<edit message=00>)." <mmc time> indicates unprocessed time
until completion.
22 47: erase status request
The command inquiring execution status of erase.
When this command is received, D-160 will reply by either "32 47 (<edit message=02>
<mmc time>)" or "32 47 (<edit message=00>)." <mmc time> indicates unprocessed time
until completion.