Filter
Top Products
D-160 Owner's Manual (Locate function)
72
SHIFT
AUTO
CLIPBOARD PLAY
LOCATE ABS 0
DIGITAL MULTITRACK RECORDER
D-160
IN / OUT
PUNCH
PGM CHANGE
8/167/156/145/134/123/112/101/9
RECORD TRACK
HD ACCESSLOCKED MTC IN
ENDIN OUTSTART
AUTO PUNCH
AUTO PLAY IN OUT
AUTO RTN
CLIPBOARD
PASTEMOVECOPY
AUTO RTN
ERASE UNDO REDO
DISP SEL
EXECUTE
/YES
EXIT
/NO
HOLD/ STORE RECALL
TIME BASE SEL
TAKE
REHEARSAL
LOCATEPUNCH
F FWDREWINDPLAYSTOPRECORD
VARI PITCH
LOCATE ABS END
Editing and storing the Start/End point
1. Press the HOLD/> key while the D-160 is playing back or stopped.
The time value at the moment when you pressed the HOLD/> key will be held
and the unit will enter the edit mode.
* The Bar/Beat Resolution menu setting is available when BAR/BEAT/CLK is used
for the Time Base. Refer to page “160” for details.
2. Move the cursor to the time value (bar) using the HOLD/> key or SHUTTLE
dial, and use the JOG dial to change the value.
3. Press the STORE key. (The STORE LED will light up.)
4. Press the AUTO RTN START key.
The edited time value will be stored as the Start point, and the display will
return to the screen displayed before you held the time value. (The STORE LED
will go off.)
5. Press the HOLD/> key again.
6. Enter the value as you did in step 2.
7. Press the STORE key. (The STORE LED will light up.)
8. Press the AUTO RTN END key.
The edited time value will be stored as the End point, and the display will go
back to the screen before you held the time value.
* In steps 1 and 5 described above, you can press the STORE key instead of the
HOLD/> key, edit the time value (bar), and then press the AUTO RTN START/
AUTO RTN END key to set the data more quickly.
4
8
2, 6
3, 7
1, 2, 5