Filter
Top Products
D-160 Owner's Manual (Locate function)
69
2. Locate
The following table shows how to locate to a data point.
Use the following key sequences to locate a certain point.
In this table, "+" indicates that you need to press the specified key while pressing
and holding down the STOP button.
"->" indicates that you need to first press one key, then press a second key.
1 STOP+REWIND Locates the beginning of the hard program (ABS 0).
2 STOP+F FWD Locates the end of the recorded area on the program (ABS END).
3 CLIPBOARD IN->LOCATE Locates the stored Clipboard In point.
4 CLIPBOARD OUT->LOCATE Locates the stored Clipboard Out point.
5 AUTO RTN START->LOCATE Locates the stored Auto Return Start point.
6 AUTO RTN END->LOCATE Locates the stored Auto Return End point.
7 AUTO PUNCH IN->LOCATE Locates the stored Auto Punch In point.
8 AUTO PUNCH OUT->LOCATE Locates the stored Auto Punch Out point.
9 LOCATE Locates the stored Locate point (see the note below).
Also, follow the procedure below to locate directly to the point of a time value
(bar/beat/clock).
1. While the recorder is playing back, press the HOLD/> key at the time value (bar/
beat/clock) you wish to store.
The time value of the point at which you pressed the HOLD/> key is retained,
and the D-160 enter the edit mode. "LOCATE" will light on the display.
2. Use the HOLD/> key or the SHUTTLE dial to move among the digits of the time
(bar/beat/clock), and use the JOG dial to adjust their value.
3. Press the LOCATE key.
The D-160 will locate the point of the edited time value, and the Time Base
indication will be restored. ("LOCATE" lights up on the display.)
LOCATE
LOCATE
LOCATE point
STOP point
You can set the preroll point within a
range of 0 to 10 seconds (Refer to page
"149" for details.)
<Notes>
* Each time a different Memory location (3-8) is located, the LOCATE key memory will
be automatically overwritten by the new time value (bar/beat/clock) of the point that
was just located. For example, assume that the LOCATE key has a Memory location of
00h: 05m: 40s: 00f: 00sf. When you locate an AUTO RTN START point of 00h: 03m:
00s: 00f: 00sf. If you do not perform a different locate operation, the LOCATE key
memory will not change and will always allow the unit to locate to the same point (bar/
beat/clock).
* You can check the LOCATE key memory data by pressing the RECALL key, and then
the LOCATE key. You can also edit this data, and store the LOCATE key's own data by
pressing the STORE key, and then the LOCATE key.